Singer 6233 - Accessories Included

Principal
Parts
1. Hand Wheel provides
a means for 14. Presser
Foot Lifter, at the back
of
raising or lowering
the needle.
machine,
lets you
raise and lower
2. Bobbin Winder lets you fill the bobbin presser foot,
with thread
quickly and
easily.
IS.
Thread
Cutler, on
presser
foot
3. Pattem
Display
Panel
shows
a vari-
sleeve,
is built-in
for ease,
ety of pattems
available
for your sew-
16. Slide
Plate opens
for easy removal
ing needs.
and
replacement
of bobbin.
4. Friction-Free
Spool Pin
and Cap 17.
Feed system
moves fabric
under
hold the top
thread supply and
allow it presser
foot.
to unwind
smoothly
as
the spool
does
.
Pnsr
Foot
holds
fabric
against
the
not turn,
feed
system and snaps on and off
5.
Stitch
Width
Lever
controls
the width
of
pattems
and
sets
the needle
for 19m
Bed
is the
work
surace
of
the
straight
stitching.
machine.
6.
Snap-InThreadGuidehelpstoinsure
20.
Sthch
Length
Lever
allows
for
a
a
smooth flow
of thread from
the
varetyofstitchlengths.
spool to the
tension.
21. Power
and Light Switch
turns on
the
7. Bobbin
Winder Tension
Disc
pro-
machine and
sewing light
at the same
vides
thread tension for bobbin time.
winding.
22.
Reverse
Lever
provides
either
8. Auto Needle Thread
Tension Lever momentary
or continuous reverse
controls top thread tension. abric movement.
9. Face Plate is a removable cover
pro- 23. Pattem Selector Dial
turns directly to
tectng movable pare s
and sewing any of the 10 patterns,
plus buttonhole,
lighm.
shown on the pattern display panel.
10. Sewing Light
illuminates sewing 24. StItch
Balance Ring adjusts appear-
area. ~ ~ ~ swig
ante of Special Stitch patterns and
buttonholes.
11. One-Way
Needle
Clamp
holds
25. Electrical
Power
Cord connects
needle in machine
and prevents incor-
your
Ctri outet.
rect insertion. machine to your
electical outlet.
12. Needle Plate
supports the fabric 26. Speed Controller, designed for safety
during sewing. and convenience, regulates
the elec-
tronic solid state speed control.
13.
Removable
Extension
Table
lets
you
change
the machine
bed
from flat
to
free
arm.
3