Singer C240 - Machine Alerts and Sound Settings

19
Warning Messages/Sound
Main Motor Overloaded
Your sewing machine can get overloaded when sewing
on heavy fabrics e.g,. the thread gets twisted or jammed
or the hand wheel axle cannot move. A monotone beep
sound is heard and the letters "EL" ash on the LED
display. Please refer to the Troubleshooting section of
this manual to nd a recommended solution. When the
problem has been solved, the machine will continue to
sew.
Note: When sewing, if the thread gets jammed inside
the hook preventing the needle from moving and you
continue pressing the foot control, the security switch
will stop the machine completely. Restart the sewing
machine by switching the ON/OFF switch to the OFF
position and then ON again.
Bobbin Winding Position
When the bobbin lever is pushed to the right, the letters
"SP" ash on the LED display.
If you press any button, a beep will inform you to push
the bobbin winder spindle to the left, sewing position.
Note: You cannot sew in bobbin winding position.
Machine Sound
It is possible to turn off the sound on the machine
buttons. Press the Immediate Tie-off Button (A) while
turning on the machine.
Select between the audio on or off by touching the stitch
width “+” or “–” buttons (B).
Touch “-” to turn off the audio and the display will show
“0”. Touch “+” to turn on the audio and the display will
show “1”.
Press the Immediate Tie-off Button again to return to
sewing mode.
A
B