Singer C240 - Getting Started: Preparations; Unpacking and Initial Setup; Connecting Power and Foot Control; Packing Away After Use

9
A
B
C
Preparations
Unpacking
1. Place the box on a steady, at surface. Lift the
machine out of the box, remove the outer packaging
and lift off the machine carrying case.
2. Remove all outer packing material and the plastic
bag.
Note: Your sewing machine is adjusted to provide the
best stitch result at normal room temperature. Extreme
hot and cold temperatures can affect the sewn result.
Connect to the Power Supply
Among the accessories you will nd the power cord and
the foot control.
Note: Consult a qualied electrician if in doubt as to
how to connect the machine to the power source. Unplug
the power cord when the machine is not in use.
For this sewing machine, foot control model C-9002
manufactured by CHIENHUNG TAIWAN., LTD must
be used.
1. Connect the foot control cord to the front socket on
the bottom right side of the machine (A).
2. Connect the power cord to the rear socket on the
bottom right side of the machine (B). Plug the cord
into the wall socket.
3. Press the ON/OFF switch to ON to turn on power
and light (C).
Pack Away After Sewing
1. Switch the main switch off.
Note: After switching off, residual power may still
remain in the machine. This may cause the light to stay
on for a few seconds while the power is consumed. This
is normal behavior for an energy efcient appliance.
2. Unplug the cord from the wall socket and then from
the machine.
3. Unplug the foot control cord from the machine.
Wind the cord around the foot control for easy
storage.
4. Place all accessories in the Removable Storage
Compartment. Slide the Removable Storage
Compartment on to the machine around the free
arm.
5. Place the foot control in the space above the free
arm.
6. Put on the hard cover.
For the USA and Canada
This sewing machine has a polarized plug (one blade
wider than the other). To reduce the risk of electric
shock, this plug is intended to t in a polarized out-
let only one way. If the plug does not t fully in the
outlet, reverse the plug. If it still does not t, contact
a qualied electrician to install the proper outlet. Do
not modify the plug in any way.