Singer C440 - Threading the Machine: Bobbin Insertion; Inserting the Wound Bobbin

18
InsertingtheBobbin
1. Place bobbin into bobbin case, making sure the bobbin
turns in a counter-clockwise direction.
a
ThreadingtheMachine
2. Draw thread into notch (a) while holding the bobbin lightly
with your nger.
3. Pull thread along the groove, up and around the top, to the
left, then down.
Pull thread to the right to cut the thread.
4. Replace the bobbin cover. Set the left tabs into the holes in
needle plate and push the right side of bobbin cover down
until it clicks into place.
NOTE: This machine can start to sew without drawing up the
bobbin thread. If you want to draw up the bobbin thread, see
page 20. Be sure to use only SINGER
®
Class 15 bobbins
(transparent) in this machine.