Singer C440 - Sequencing: Executing and Modes; Recalling and Sewing Sequences; Single Sequence Mode

42
SewtheSequence
After selecting stitches for a sequence, the sequence will sew
repeatedly.
1. Attach the Satin Foot when sewing decorative & letter
stitches.
2. Lower the presser foot and start sewing. Machine will start
sewing from rst entered pattern, and sew the sequence
repeatedly.
SewingSequencefromtheBeginning
Whenever pressing the Restart button, machine will start
sewing sequence from beginning.
NOTE: By pressing the Thread Cutter button while sewing,
machine will stop at the end of sequence and cut threads.
SingleSequenceMode
By pressing the Single Sequence button, the icon will change
to a circle and activate the single sequence mode. This mode
has two functions.
1. Adjustments as one stitch pattern: The value of stitch
length and width are now common for all stitch patterns in
the sequence. You can change the length/width and mirror/
reverse of all stitches as one stitch pattern.
2. Sewing one single time:
The stitch sequence will sew one
time and then stop at the end of the sequence.
NOTE: In this mode, the Delete button is not activated. Press
the Single Sequence button again to activate.
Sequencing
ToRecallMemorizedSequence
1. Press the Load button on the Sequence Screen.
2. The memories are indicated by numbers. Press the
desired sequence/memory.
3. When the selected le number is highlighted, press the “
✓
”
button.
4. Recalled sequence is shown on the left side of LCD.
You can now sew the recalled sequence.
NOTE: If another sequence has been created or loaded before
loading from memory, the loaded sequence will be added at
the cursor position.