Singer S18 - Machine Identification and Preparation; Machine Identification; Getting Ready to Sew; Connecting the Power Supply

1
Face plate
Top cover
Set screw (B)
Setscrew (C)
Connector (D)
Connector case
Pressure dial
TO REMOVE BELT COVER AND MACHINE BASE
Face plate
[ To remove]
Remove the setscrew (A) to remove the face plate.
[ To attach]
Attach the face plate with the setscrews (A).
Top cover
[ To remove ]:
1. Remove the setscrews (B) and (C).
2. Pull out the connector (D) of the bobbin winder and remove the top cover.
[ To attach ]:
3. Connect the connector of the bobbin winder and tighten the setscrews (B) and (C).
Setscrew (A)