38
5mm (C)
Setscrews (D)
Plunger (B)
Yoke (A)
1. Remove the belt cover (refer to page 2).
2. Loosen the 2 set screws (D).
Adjust the distance to 5mm.
3. Tighten the 2 set screws (D)
4. Attach the belt cover.
TO ADJUST POSITION OF SOLENOID FOR UPPER SHAFT DECLUTCH DEVICE
The distance between the upper surface of the yoke (A) and the snap ring on the plunger (B)
should be 5mm (C) when the upper shaft declutch device is activated.
To Next Page
