© Jul 2020 7-4 GTJZ0612&0812&1012&1212 Operation Manual
OPERATING THE MACHINE
2. Ensure the platform is fully folded.
3. Ensure that the slope where you plan to drive is less
than the angle of the machine’s climbing ability.
NOTICE
Climbing ability refers to the maximum permissible
percentage of the slope when the machine is on solid
ground with sufficient traction and the platform is car-
rying only one person. As the weight of the machine’s
platform increases, the machine’s climbing capacity
reduces.
To determine the slope:
1. Use a carpenter’s rule, a straight board (longer than
1 m [3.3 ft]), and a tape measure.
Figure 7-2
2. Measure the height and length/distance of the
slope.
3. The slope measurement consists of the numbers
for the height and length/distance x 100%.
USING THE BATTERY
LEVEL INDICATOR
Use the diagnostic reading display on the platform
to determine the battery level.
Table 7-2
PLATFORM POWER DISPLAY POWER RATIO DESCRIPTION
90-100%
The battery has been fully charged.
70%
The battery is at 70% of its capacity.
50%
The battery is at 50% of its capacity.
30%
The battery is at 30% of its capacity.
20%
The battery level is at 20%, which is low. The battery re-
quires recharging.
10%
The battery level is at 10%, which is very low. The machine
will become slow. The battery requires recharging.
To Next Page
Loading...
