© Jul 2020 7-6 GTJZ0612&0812&1012&1212 Operation Manual
OPERATING THE MACHINE
1. Press and hold Select key for 10s, when the display
shows EQ in quick flashing, release the key and the
charger has been set in EQ mode.
2. To exit the EQ mode, likewise, press and hold the
Select key for 10s, when the display shows OFF in
quick flashing, release the key and the charger will
exit the EQ mode.
Charger in-built curve codes and respective battery
models
Table 7-3
Curve codes Battery models
B02
Trojan T105
B04 Discover AGM
B05
US Battery Flooded
B07
Trojan T125
B11
Trojan T1275
(two in series and two in tandem)
Note: the default curve code is B02.
THE SETTING METHOD OF
INDOOR/OUTDOOR MODE
Note: This setting method is for GTJZ1212 machines
only.
NOTICE
GTJZ1212 machine is divided into outdoor machine
and indoor machine.
Indoor machine can only be used indoor.
Outdoor machine can be set indoor mode and
outdoor mode. The maximum working platform
height of outdoor mode is 9m (30 ft), and the
maximum working platform height of outdoor model
is 11.9m (39 ft).
Indoor mode is strictly prohibited for
outdoor use. Indoor machine is
strictly prohibited for outdoor use.
For outdoor machine, the ground controller can choose
indoor mode and outdoor mode.
• Select outdoor mode, the maximum working
platform height is 9m(30 ft). that is, the platform
cannot rise after reaching 9m (30 ft).
• Select indoor mode, the maximum working platform
height is 11.9 m(39 ft). However, when the platform
height rises to 9m(30 ft), the platform will stop rising
and a sound alarm will appear. "id" will appear on
the platform control box. At this point, return the
control handle to the middle position and release the
handle. Then hold the enable switch of the control
handle and push the handle forward. The platform
can continue to rise to 11.9m(39 ft).
Indoor/outdoor mode setting steps are as follows：
1. Turn the key switch of the ground controller to the
ground control position.
2. Push the emergency stop button on the platform
controller to the ON position.
3. Push the emergency stop button on the ground
controller to the ON position while holding down the
enter button for five seconds, and the program
setting interface appears on the display screen.
4. Press page down key until the display appears "Set
Option", then press the enter button.
5. When "In or Out door" appears on the screen, then
press the enter button.
6. At this time, two options "In Door" and "Out Door"
appear on the screen.
7. Select "In Door" or "Out Door" by clicking page up
and page down keys.
8. Select "In Door", then press the enter button., The
indoor mode is set successfully.
9. On the contrary, select "Out Door", then press the
enter button., The outdoor mode is set successfully.
To Next Page
Loading...
