SINTERIT Lisa Pro - Page 8

8 | Sinterit Lisa PRO USER MANUAL (short version)
First use of the printer Subsequent use of the printer
• If the machine is lled with powder for the rst
time, after loading the le, a message will appear
that the LASER PROTECTIVE GLASS
needs to be
cleaned.
• After conrming that the previous content
(printouts and unsintered powder) of the PRINT
BED has been removed and that the work space
of the RECOATER
is not obstructed, the printer
will be ready for printing – it will start the printing
process by repositioning the BEDs
and the
RECOATER.
• After conrming that the previous content
(printouts and unsintered powder) of the PRINT
BED has been removed and that the work space
of the RECOATER
is not obstructed, the printer
will be ready for printing – it will start the printing
process by repositioning the BEDs
and the
RECOATER.
7. By clicking DONE the RECOATER and the BEDs will be repositioned (Image 16). During this operation, the
height of both BEDs is set in accordance with the currently selected printing process (Image 17).
Image 16. Positioning of the BEDs and the RECOATER screens.
Image 17. Repositioned BEDs: PRINT BED and ready to be lled with powder FEED BED
and the base position for the RECOATER .
IMPORTANT!
• When working with powders always wear protective clothing (glasses, mask,
gloves).
• For the rst use of the Sinterit LISA PRO Printer use only the powder
(for PA12 SMOOTH and PA11 ONYX) from the container labeled PRINT READY
POWDER.
• Always pay attention to the messages displayed on the LCD screen of the
Sinterit LISA PRO Printer.