6
(40) Tools equipped with chip collection and extractor hoods shall be connected to the dust and chip-
collecting device.
(41) Use the tool only for wood or similar materials.
When the blade is abraded 95%, you must change it to the new one, which must meet EN / UK standards.
(43) Two persons are required for moving round the workshop due to its heavy weight.
(44) The machine should be fixed on the floor by screws when operating.
SAFETY INSTRUCTIONS Cont.
Regularly check that blades and lock bars are locked tight in cutter block.
Max. allowable blade projection over cutter block 1.0mm/0.004 inch +10%.
Never remove any of the machines safety guards other than for servicing and repair work.
Keep guards operational at all times.
Set and secure safety guards in position before operating machine.
This machine must be safety earthed. The yellow/green (green) lead is the earth conductor.
Regularly check anti-kickback fingers for proper operation.
Always wear eye protection.
Rebating, tenoning, moulding and recessing may not be undertaken without the use of special guards.
Never make jointing or planning cut deeper than 2 mm
USER RESPONSIBILITY
This machine will perform in conformity with the description contained in this manual when installed,
operated, maintained and repaired in accordance with the instructions provided.
This machine must be checked periodically. Defective equipment (including power cable) should not be
used. Parts that are broken, missing, plainly worn, distorted or contaminated, should be replaced
immediately. Should such repair or replacement become necessary, it is recommended that such repairs
be carried out by qualified persons.
This machine or any of its parts should not be altered or changed or changed from standard
specifications. The user of this machine shall have the sole responsibility for any malfunction which
results from improper use or unauthorized modification from standard specification, Faulty
maintenance, damage or improper repair.
To Next Page
Loading...
