TROUBLESHOOTING
Problem
Cause Remedy
Machine does not start Blown Fuse Replace Fuse
Loose switch terminal Inspect back of switch
Faulty switch Replace switch
Guard not fitted
Re-fit the plastic guard
ensuring it connects with the
interlock switch
Only starts when Green
button is held down
Faulty switch Replace switch
Machine runs intermittently Worn carbon brushes in motor Replace motor brushes
Motor running but
cutterblock is not rotating
Broken or stretched drive belt Replace drive belt
Motor slows down during
the cut
Depth of cut is too great Take a smaller cut
Dust & Chip collector hood
is blocked
Clear the blockage and
ensure the extractor is
functioning correctly
Planing knives are blunt Replace or sharpen knives
Excess Vibration Planing knives out of balance Reset the height of the knives
19
To Next Page
Loading...
