SILVERCUT
29
Detail of the screw joint
Mounting the curtain; dismantle sequence
– Joints (4)
– Joints (1)
– Joints (2)
– Joints (3)
– Removing the curtain
After placing the new curtain perform the mounting in
opposite direction.
– Only manufactured protective curtains
suit the safety regulations!
7.5 Replacing the blade holders, mower blade and
screw
The blade holder gets worn out during the work. When
the holder gets worn out for width of 2 mm, it must be
replaced with new one.
If the sliding screw surface wear aut to max. 1,9 mm,
replace the screw (see picture).
If the blade hole increased to max. 21 mm, replace the
mower blade (see picture).
49
1
50
2
3
51
52
4
53
54
To Next Page
Loading...
