Y070.020/GB Page 35
Operation instructions
SIPOS 5 PROFITRON, HiMod
5
Commissioning
5 Commissioning
8. Slowly turn the central wheel in the same direction
1
) as it
has turned when approaching the end position (see note
in operation step 6), until „0“ is shown as „deviation“ in the
display. If the central wheel has already reached the stop,
turn in the opposite direction.
1
) From fi rmware version 2.56, an arrow in the display indicates
the direction of rotation:
► = Turn central wheel clockwise.
◄ = Turn central wheel anti-clockwise.
Now the potentiometer or the magnetic position sensor
are adjusted.
If the “ENTER” button is pressed before adjustment to
0, the „adjust of poti – necessary” display appears. If
you press „ENTER” again, you return to the start of end
position adjustment; „endpos. adjust“ is displayed.
adjust of poti
deviation 0
9. Confi rm with ENTER. The fi rst end position is set and the
system changes to setting the other end position. The
second line indicates:
– for travel-dependent cut-off mode „press E-button“;
– for torque-dependent cut-off mode „until TL reached“.
10. If the actuator is equipped with a mechanical position
indicator, we recommend setting it now. Separate approa-
ching of the end position can thereby be avoided. For the
setting, refer to the following chapter 5.6.5.
move to cl.pos.
until TL reached
11. Move the actuator to the other end position:
– Travel-dependent cut-off mode
a) Use the CLOSE
button (OPEN button for setting in
OPEN direction) to move the actuator, until the valve
has reached the end position. Pay attention to the
valve during operation.
Note: If the cut-off was torque-dependent due to a
block, e.g. in case of a sluggish MOV, an unfavorable
torque curve (cancel by pressing the and buttons
simultaneously), this is indicated by „TL-OPEN activ“
or „TL-CLOSE activ“ in the second line. The same ap-
plies to approaching the mechanical end stop (return
to the desired end position using the or buttons).
% open close
E +
b) Once the end position has been reached, confi rm
after approx. 2 s. with the ENTER button. The display
confi rms the correct setting. Continue with operation
step 12.
If „increase it!“ or „decrease it“ is displayed, press
the ENTER button and adjust the slide wheel in the
signaling gear accordingly (refer to chapter 5.6.2) and
repeat the settings of end positions.
sign. gear ratio
adjustment ok!
To Next Page
Loading...