Sirman PPJ 10 SC - General Precautions; Safety Devices Installed on the Machine

4
CHAP. 1 - MACHINE INFORMATION
1.1 - GENERAL PRECAUTIONS
•The machine must only be used by trained personnel who are perfectly aware of the safety norms
contained in this manual.
•If there is a turnover of staff, promptly provide proper training for new personnel.
•Even if safety devices are installed on the machine do not place hands near moving parts and avoid
touching the machine with wet or damp hands.
•Before carrying out any type of maintenance or cleaning, disconnect the machine plug from the
electrical outlet.
•The machine must only be used by trained personnel who are perfectly aware of the safety norms
contained in this manual.
•If there is a turnover of staff, promptly provide proper training for new personnel.
•Even if safety devices are installed on the machine do not place hands near moving parts and avoid
touching the machine with wet or damp hands.
•Before carrying out any type of maintenance or cleaning, disconnect the machine plug from the
electrical outlet.
•When intervening for mainteannce or cleaning purposes (therefore the protections are removed)
carefully evaluate residual risks .
•During maintenance or cleaning always concentrate on the operations in progress.
•Regularly check the state of the feeding cable (completely unwinding the cable, avoiding twisting it, is
advisable to avoid potential risks); a worn or broken cable can present serious danger of the electrical
kind; avoid compressing the wire with weights, leaving it in contact with hot or sharp surfaces and
pulling on it to unplug it from the outlet.
•If the machine shows signs of malfunctioning or does not work, do not use it or try to repair it; contact
the “Assistance Center”, indicated on the back of this manual.
•The combination of the OUT and START pushbuttons must only be used for unloading the worked
product.
•The machine must only be used for cleaning potatoes / mussels / onions.
•The manufacturer is not responsible in the following cases:
 if the machine is mishandled or the safety devices are installed by unauthorized personnel;
 if components are replaced with unoriginal parts;
 if the instructions in this manual are not followed carefully;
 if the machine surfaces are treated with inappropriate products ( inflammable, corrosive or harmful
substances).
1.2 - SAFETY DEVICES INSTALLED ON THE MACHINE
The safety devices against risks of electrical nature conform with the directives 2006/95/CEE,
1935/2004CEE, while the mechanical safety devices conform with the directives 2006/42 CEE.
The machine is equipped with:
• a starting device consisting of a control card insulated in IP 34, 24 Volts,
which enables:
turning the machine on and off;