7
GB
7
Safety Precautions
Caution
Do not touch the mill blades
Be sure to use the supplied brush to clean the mill.
Failure to do so may cause injury.
If mineral water or alkaline ionized water
is used, clean frequently
Mineral scale can adhere to the inside of the main
unit, or the adhered mineral scale can drop off and
block the hot water and steam outlets in the main
unit, causing malfunction.
Do not place the power cord on the
warming plate immediately after use
when it is still hot
The power cord may be damaged, resulting in fire
or electric shock.
Do not fill the water tank above the full
water mark (MAX)
Hot water may spill or come out of the bottom of
the unit, causing scalding.
Do not use the power cord where it will
interfere with traffic or operation
The power cord may snag, causing the product to
fall, resulting in injury or malfunction.
Do not use exposed to direct sunlight for
a long time
This may cause malfunction.
Put nothing but coffee beans in the mill
This may cause malfunction.
Do not run the mill continuously without
water
This may cause malfunction.
Do not cover the main unit with a dish
towel or similar
This may cause deformation or malfunction.
Do not use in places where steam may
contact other electrical equipment
Steam may cause fire, malfunction, discoloration,
or deformation of electrical equipment.
Do not open the hopper lid or basket
during use
This may cause injury or scalding.
Do not touch the filter directly
immediately after brewing
This can cause scalding.
Do not detach the water tank during use
Do not use outside
This may cause malfunction.
Do not use it overhanging a table, etc.
This may cause injury or scalding.
Do not put your hands under the basket
during use or for a while after use
Dripping can cause scalding.
Do not use on carpets or fabric
tablecloths
Coffee splatters can stain carpets and tablecloths.
To Next Page
Loading...
