Page 6
L) To deposit the preset litres through the deposit hose 19 , p ress
“START” 13 and the unit will automatically deposit the set amount
(the accuracy will be w ithin 2%). You can stop the deposit at any
time by pressing “STOP” 12. The litre amount 18 remaining to be
deposited will flash, to complete the deposit press “START”. If you
want to cancel the deposit press “STOP” again. The machine resets
to the previous deposited amount.
M) When the “START” button is pressed the deposit light 16 w ill
light up.
N) When the “START” button is pressed the compressor, element,
recirculation pump and water fill will stop and or switch off if they
were on when the start button was pressed. (If not enough time is
given to allow the tank to fill and the set temperature to be reached
you will not be able to get a full deposit at the right temp erature.)
O) After the set quantity of water has been deposited the deposit pump
will stop and the tank will automatically commence filling.
P) At the end of the d ay w hen you have finished your production.
Press “ON/OFF” to turn the machine off. (It is not recommended
that you leave the machine on w hen not in use. Leaving the machine
on will cause excess wear and tear on working parts, therefore this
may reduce the life of the machine.)
Q) If the machine overheats during a working cycle the red wa rning
light 17 will come on.
To Next Page
Loading...
