N7 Autopilot User Manual (ArduPilot) v1.0
9
Before starting the operation, be sure to check the power of the remote controller and
the power supply voltage of the air unit.
When finishing the operation, first power off the air unit and then the remote controller.
Before setting the remote controller parameters, be sure to power off the engine and
motor to prevent accidental start.
Before starting the operation, be sure to pre-set the fail-safe function on the remote
control or in the ground station software.
When installing, please avoid installing the air unit and GPS module too close to avoid
interference. It is recommended that the distance between the air unit and the GPS module
be longer than 20 cm.
Storage / Carrying / Recycling
When the SIYI product you own is idle, or you want to take the SIYI product out for
work, or the product has reached the end of its service life, please pay special
attention to the following matters:
DANGER
When SIYI products are not in use, they should be kept away from areas easily accessible
to children.
Please avoid placing SIYI products in an environment that is too hot (above 60 degrees
Celsius) or too cold (below minus 20 degrees Celsius).
To Next Page
Loading...