1. Place die on Cutting Pad. Place material over die and align. Place another
Cutting Pad over the material and die to create a “sandwich.”
2. Use the forward/reverse switch to select the proper direction. Slide
“sandwich,” Platform into the roller opening as far as it will go. Push in on
the side aps to align the “sandwich” and gently press the motor button.
When the “sandwich” is completely through the rollers, then and only
then is it safe to remove or handle your die and die-cut shape.
Using Framelits™, Thinlits™, Triplits™
and Other Thin Dies
Paper
Cutting Pads
Die
Thin Die Adapter
Platform
Platform
Thin Die Adapter
“Sandwich”
To Next Page
Loading...
