To close the Vagabond 2 Machine, push the doors closed
until you hear the latches engage with a click.
OPERATING THE VAGABOND 2:
To operate the machine, rst open the doors. Then select the direction
of the motor by sliding the forward/reverse switch in either direction.
Once the desired direction has been determined, depress the motor on/
o button. The motor will stay on only while the button is being pushed. If
you take pressure o of the button, the motor will stop. (Note: The machine
moves in forward and reverse, allowing for reversal of direction at any
time. This also makes for convenient loading and handling of shape-
cutting products from either end of your Vagabond 2 Machine.)
Do not attempt to touch or remove the shape-cutting products from the
Vagabond 2 Machine until you have released all pressure from the motor
switch and all materials are clear of the rollers. Then, and only then, is it
safe to remove or handle your die and die-cut shape.
Forward/Reverse Switch Motor On/O Button
To Next Page
Loading...
