www.skcltd.com 210-PMTXM Issue L Page 31
Pocket Pump MTX Replacement Parts
Item Part No. Description
1 P20120GY Pump case kit including sliding keypad cover, belt clip and screws
2 P51821 Belt clip
3 P20131GY Sliding keypad cover
4 P21001 Pump case screw kit
5 P79360 Keypad
6 P40010 Inlet filter (pack of 10)
7 P20129MTX Battery pack 2.4V 1.0Ah NiMH
SKC recommend that our air sampling pumps are regularly serviced by one of our Authorised Service Centres.
Due to the safety implications associated with the incorrect repair of ATEX certified intrinsically safe products
for use in potentially explosive atmospheres, it is our policy to only supply the complete range of replacement
parts to our Authorised Service Centres who are trained in the service and repair of these products.
Care must be taken when dis-assembling and re-assembling the pump to replace the above listed internal parts
to ensure that no components are damaged or incorrectly assembled as this could affect pump performance
and/or invalidate the ATEX certification of the pump. Do not apply excessive force when tightening the screws.
If in any doubt contact your local distributor or SKC on +44 (0) 1258 480188.
The range of replacement parts listed above is available to all customers. If the required part is not listed,
contact SKC customer care on +44 (0) 1258 480188.
Note: Table item numbers correspond to the ringed numbers shown in the figure on page 30 of this manual.
To Next Page
Loading...
