Specifications
Lubricant output (in
(cm
)) Reservoir Lubricant operating pressure
Ratio Per cycle Per min at psi (, bar) capacity Air inlet Lubricant outlet Type of system Minimum Maximum Recommended
:
.
)
(,) pints
/ in NPTF
/ in NPTF SL- psi psi psi
( l) SL- (, bar) (, bar) (, bar)
SL-
SL-
Description
Model oil pump is used as the
pumping unit for a centralized lubrication
system having a single line circuit of SL-,
SL-, SL- or SL- injectors.
It is an air operated reciprocating pump
that discharges an established amount of
lubricant (
.in
(, cm
))
)
into the
circuit for each pump cycle.
This pump can be used with an air control
system, a time control and a pressure switch
supplied by the owner/operator.
WARNING
Do not operate unit with combustible
gas.
Failure to comply may result in
serious personal injury and/or damage
to the equipment.
)
Based on lubricants that are free of entrapped air. Lubricants that are aerated will reduce output of pump.
NOTE
Pressure is set and controlled through
pressure switch.
To Next Page
Loading...
