SKF Multilog IMx-S 32 - Default Chapter; Table of Contents

SKF Multilog On-Line System IMx-S TOC - 1
User Manual – Revision S
Table of Contents
Introduction 1
Important Messages ............................................... 1-1
System Overview .................................................... 1-2
IMx-S Unit ............................................................... 1-3
System LED Indicators ............................................ 1-4
Installation 2
Safety Considerations ............................................. 2-1
Scenario .................................................................. 2-1
Supply Cable ........................................................... 2-2
Mains Power ........................................................... 2-2
Sensor Cables .......................................................... 2-4
Ethernet Cable ........................................................ 2-4
Ethernet Connections ............................................. 2-5
Cable Glands ........................................................... 2-5
Unit Configuration 3
Analogue Inputs ...................................................... 3-1
Digital Inputs ........................................................... 3-3
RS485 Communication ........................................... 3-5
Relay Driver Outputs .............................................. 3-6
Dig1 Buffered Output ............................................. 3-7
Network Configuration ........................................... 3-8
IMx-S Time ............................................................ 3-10
Hardware Maintenance 4
Troubleshooting Guide 5
Sensor circuits ......................................................... 5-1
Relay driver outputs ............................................... 5-7
Connections to Monitor ......................................... 5-8
Checking Modbus RTU, RS485 communication ...... 5-8
Technical Data 6
Environmental ........................................................ 6-1
Power Supply .......................................................... 6-1
Analogue Inputs ...................................................... 6-2
Digital Inputs ........................................................... 6-2
Outputs ................................................................... 6-2