9
SKF TIH 100m
4. Preparation for use
• Place the TIH 100m in the horizontal position on a stable surface.
• Connect the mains plug to a suitable mains supply.
• Plug the remote control into the connector on the carrying handle side of the heater.
• Mount the swivel stud on the vertical post side of the swivel arrangement. See the
illustrations at the beginning of this manual. Position the large yoke swivel on the
swivel stud.
• For workpieces with an internal diameter large enough to fit over the inductive coil,
follow these steps:
- Open the foldable bearing support and position them as shown on the illustrations
at the beginning of this manual.
- Place the workpiece over the inductive coil using appropriate lifting equipment.
- For best performance, adjust the position of the workpiece so that the inductive
coil is in the centre.
- Close the swivel yoke so that it completely covers the top of both vertical supports.
• For workpieces that do not fit over the inductive coil, follow these steps:
- Choose the largest of the three yokes that fit through the internal diameter of the
workpiece.
- Slide the workpiece onto the yoke that you have selected.
- Heavy workpieces (= 9 kg (19.8 lbs)) that must be installed on the top yoke should
be supported until the yoke is in the correct position on the coil side post. The
heater may tip over if the workpiece is not supported.
- Position the yoke on the TIH 100m with the bright underside resting evenly on the
two vertical supports.
• If you will use TEMP MODE, plug the temperature probe into the connector on the
carrying handle side of the heater. Place the magnetic end of the probe on top of the
inner ring of the bearing or on the innermost surface of the workpiece.
• Switch on the TIH 100m.
• Observe the self-test of the remote control display and signal tone.
English
To Next Page
Loading...
Need help?
General
