To Next Page

To Previous Page

9EN

2.1 Installation of new lubricators

For installation at the application follow the steps:

Clean the lubrication point from dirt and

old grease in such a way that the dirt is not

entering the lubrication point itself.

Remove the yellow protection cap from the

new grease cannister.

Screw the support ﬂange on the cartridge

until is it is ﬁxed.

If the support ﬂange is mounted already on

the application, don’t remove it. Use sealing

tape on the thread of the new cannister tip.

Questions and Answers:

Need help?

Do you have a question about the SKF TLSD 1-DK and is the answer not in the manual?

SKF TLSD 1-DK Specifications

General