Should the rewind starter rope fray and
break, remove starter unit using tool
supplied
with
the vehicle. Transfer rope
handle to your emergency rope. Make
a knot at the end
of
emergency starter
rope
and wind rope around rewind
starting pulley. Pull vigorously as per
usual manual starting.
By raising the outer attachment
of
the bogie wheel sets vehicle maneu-
verability in deep snow will increase.
You will note that
there are partially
dril!ed holes located approx.
1-<
3/8"
above the original cross shaft holes
of the frame. To reposition bogie wheel
sets, drill holes fully through
a
5/
16"
dia, drill. Remove capscrews
securing bogie wheel cross
shafts
to
frame and reinstall bogie wheels in
new
position.
O
NOTE: Once holes have been
drilled, the bogie
whee! set po-
sition
is inter-changeable.
To Next Page
Loading...
