NOTE:
Without
these
inserts
continual abrasion
would
wear
and cut the track therefore,
81
ways replace a missing or dam-
aged insert as soon as possible,
The tension of each track should be
214"
± 1 /
a"
between
top
inside edge
of track and
bottom
of footboard.
lift
the rear of vehicle and support it
otf
the ground, Using a rule, check track
tension at
the second set of bogie
wheels
from
real',
Lift
rear of vehicle and support it
off
the
ground. Place gear shift lever in for-
ward position,
With
engine
off,
rotate
tracks by hand
and inspect condition. If
bad cuts or
missing track inserts are
noted, see your dealer.
Visually inspect suspension springs.
Replace any
weak or broken spring.
o
CAUTION: Do
not
allow cleaning
solution to enter battery.
It will
destroy the chemical properties
of
the electrolyte.
WARNING: Overflow tube must
be freo and
open. A kinked or
bent tube wi!! restrict ventilation
and create gas accumulation
that
Gould result in an explosion.
Avoid skin contact
with
electro-
lyte.
,A
Iter reconnecting battery, coat battery
terminals and connectors
with
petro-
leum jeliy to prevent corrosion, Check
that battery is well secured and that
battery
overflow tube is not blocked or
kinked.
Check
electrolyte
level.
Electrolyte
level must be at upper level line on
battery casing,
if necessary add distilled water. Battery
'connections
must also be free of cerro
sian, Ij cleaning is necessary, remove
corrosion using a stiff brush then clean
with
a solution of baking soda and
water. Rinse and dry well.
15
To Next Page
Loading...
