General
Inspection
Remove any dirt or rust. Grease at
all
recommended grease points. Wipe off
surplus.
Block air intake hole and exhaust sys-
tem hole using clean cloths .
..r
CAUTION : Plastic alloy
compo-
T
nents
such as fuel
tank,
wind-
shield, controls, etc., can be cleaned
using mild
detergents
or isopropyl al-
cohol and a
soft
clean cloth. Never
clean plastic parts
with
strong deter-
gent, degreasing agent, paint thinner,
acetone, etc. Never clean RIM
Metton
hood
with
cleaners
or
products
con-
taining chlorine.
Do
not
apply isopro-
pyl alcohol
directly
on decals.
Inspect the hood and repair any dam-
age.
Clean the frame.
For
the unpaint-
ed
aluminum portion use only "Alumi-
num cleaner" and follow instructions
on the container.
Touch up all metal spots where paint
has been scratched off. Spray
all
metal
parts with metal protector. Wax the
hood and the painted portion of the
frame for better protection.
0
NOTE
:Apply
wax on glossy fin-
ish
only. Protect the vehicle with
a cover to prevent dust accumulation
during storage .
..r
CAUTION : The snowmobile has
T
to
be stored in a cool and
dry
place and covered
with
an opaque tar-
paulin. This
will
prevent sun rays and
grime
from
affecting
plastic
compo-
nents
and vehicle finish.
--------------------------
45
To Next Page
Loading...
Need help?
General
