1. Insert key in ignition and turn to ON
position.
2. Test
throttle
control
lever.
3. Activate primer (2 to 3 times). Pri-
mer
is
not
necessary
when
engine is
warm.
4. Make sure the tether
cut-out
cap is
in position and
that
the cord is at-
tached to
your
body. Check
that
the
emergency
cut-out
button
is in
the
released upper position.
5. manual starter handle firmly
and pull slowly until a resistance
is
felt then pull vigorously.
Slowly
re-
lease rewind starter handle.
.&.
WARNiNG:
Do
not
apply
throttle
...
while
starting.
6. Check operation
of
the emergency
Gut-out
switch,
and tether switch.
Restart
vll~-411
II;:; •
.&.
WARNING:
If engine does
not
...
shut-off
when
applying
the
emer-
gency
cut-out
switch
and /
Of,
pulling
the
tether
cut-out
cap,
stop
the
engine
by turning
off
the
ignition key. Do
not
operate
the
vehicle further, see
your
dealer.
7.
Allow
the engine to
warm
before
....
,.."
......
".'"'l,t,,...,,.....
at full throttle.
..
CAUTiON:
Since engine cooling
..-
is in
effect
nnly
when
the
vehiole
is in
motion,
prolonqed idling and
low
speed operation
may
cause engine
damage. Do not allow the engine to
idle
for
more than brief periods. It is
not
recommended to pull a trailer or sled
with
this
vehicle, engine overheating
may
occurs.
Activate the
throttle
control lever
several times to check
that
it oper-
ates
easily
and
smoothly.
The
throttle
control
lever
must
return to
idle position when released.
Check
that
the
skis and the track are
not
frozen to
the
ground
or
snow
surface and
that
the steering oper-
ates freely.
Activate
the
brake control lever and
make sure the brake fully applies be-
fore the brake
control lever touches
the handlebar grip.
Check fuellevel.
Verify
that
the
path
ahead
of
the ve-
hicle is clear of bystanders and
obstacles.
.&.
WARNING:
Only
start
your
...
snowmobile
once
all
components
are checked and
functioning
properly.
8
position
starting
engine
lower
position
to stop engine
To Next Page
Loading...
Need help?
General
