Driven
pulley
support
2. Open the driven pulley by twisting
and pushing the sliding half. Hold in
fully open position.
~
•
WARNING: Never start or run
engine
without
drive belt in-
stalled. Running an unloaded engine
is
dangerous.
1. Tilt 'cab and pulley guard, unlock
and raise driven pulley support.
3. Slip slackened belt over the top ed-
ge of the sliding half.
~
Routine maintenance is necessary for
all mechanized products, and the
snowmobible is no exception. A weekly
vehicle inspection contributes to the
life span of the snowmobile as well as
retain safe and trouble-free operation.
It is recommended that the steering
system and suspension, be lubricated
monthly or every 40 hours of opera-
tion. If the vehicle is operated in wet
snow or in severe conditions these
items should be lubricated more fre-
quently.
•
WARNING: Only perform such
procedures as detailed in this
manual. It is recommended
that
dealer
assistance be periodically obtained on
other components / systems
not
cov-
ered in this
manual. Unless otherwise
specified, engine should be turned OFF
for all lubrication and maintenance
procedures.
WARNING: Engine should be
running only when pulley guards
are secured in place.
Tilt cab. To tilt drive pulley guard re-
move clip and unscrew wing nut (A).
If necessary to remove driven pulley
guard remove nuts (8) and (C).
4. Slip the belt out from the drive pul-
ley and remove completely from
vehicle. To install drive belt, reverse
procedure.
10
To Next Page
Loading...
