Skil 3400 - Lubrication; Accessories; Assembly of Tool Stand; Assembly of Table Extension

3
FIG. 49
54.
Lubrication
The gear case has been completely lubricated at the factory.
However, after six months to one year, depending upon use, it’s
wise to return your tool to the nearest Service Center for the
following:
• Brushes replaced.
• Parts cleaned and inspected.
• Relubricated with fresh lubricant.
• Electrical system tested.
• All repairs.
The following parts should be oiled occasionally with SAE No. 20
or No. 30 oil (Fig. 49).
1. Depth screw hinge.
2. Depth screw threads.
3. Tilt shaft pivot points (3).
Item Cat. No.
6 Inch Dado Set ........................................80050
Table Insert (Dado Set) ..................................80075
Table Extension.........................................80089
Tool Stand..............................................80093
Dust Collection Kit ......................................80099
Full range of 10" Circular Saw
Blades Available ..............................See Skil Catalog
Use only recommended accessories. Follow
instructions that accompany accessories. Use of
improper accessories may cause hazards.
Recommended
Accessories
WARNING
!
1
2