Skil 3410 - Unpacking and Checking Contents; Assembly Time

15
Amp
10”
Blade
Hoja Ø 254mm
Lame Ø 254mm
11
10
9
8
7
6
5
4
3
2
1
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
7
5
4
8
2
6
3
1
FIG. 3
FIG. 4
11.
Unpacking and Checking
Contents
To avoid injury from unexpected starting or
electrical shock during unpacking and setting up,
do not plug the power cord into a source of power. This cord must
remain unplugged whenever you are working on the table saw.
Model 3410 Table Saw is shipped complete in one carton.
Separate all parts from packing materials and check each one with
the illus tration and the list of Loose Parts to make certain all items
are accounted for before discarding any packing material (Fig. 3).
If any parts are missing, do not attempt to
assemble the table saw, plug in the power cord or
turn the switch on until the missing parts are obtained and are
installed correctly.
Table of Loose Parts
ITEM DESCRIPTION QTY.
1 Table Saw Assembly 1
2 Rip Fence 1
3 Table Insert 1
4 Barrier Guard Assembly 1
5 Anti-Kickback Device 1
6 Miter Gauge 1
7 Push Stick 1
8 Outfeed Assembly 1
TABLE SAW STAND
9 Leg (A) 4
10 Front - Top Rail (20-1/4" Long) (B) 2
11 Front - Bottom Rail (24-1/4" Long) (C) 2
12 Side - Top Rail (17-3/4" Long) (D) 2
13 Side - Bottom Rail (21-3/4" Long) (E) 2
14 Carriage Bolt (5/16" - 18 x 5/8") 24
15 Hex Nut (5/16" - 18) 24
16 Leg Pad 4
PARTS FOR TABLE SAW MOUNTING
17 Hex Bolt (5/16" - 18 x 1-3/4") 4
18 Flat Washer (5/16") 4
19 Hex Nut (5/16" - 18) 4
NOTE: Remove styrofoam block (for shipping purpose only)
located between the table and motor (Fig. 4). You may cause
damage to the blade elevation system if trying to raise blade if
styrofoam is not removed.
Assembly Time
The expected time to assemble and properly adjust this saw is two
hours.
WARNING
!
WARNING
!
12
13
17
18
19
16
15
9
11
10
14
3410 2610013681 ENG:2610008499 7/20/10 2:14 PM Page 11