Skil 3540 - Making a Miter Cut; Making a Bevel Cut; After Use Procedures

20
Making a Miter Cut
1. Adjust the parallel rip fence to the desired
distance from the tile blade, using the scale
rules on the table surface for reference.
Tighten the fence-locking knobs on each
side to rmly lock the parallel rip fence on
the table. (Fig. 8)
2. Use the angle guide supplied in conjunction
with the parallel rip fence.
3. Select the desired angle and tighten the
screw to secure the angle guide (Fig. 10).
4. Place the tile against the angle guide. (Fig.
10).
5. Hold the tile rmly against the angle guide
and feed it slowly toward the rotating tile
blade.
Making a Bevel Cut
1. Loosen the bevel cutting knobs on both
sides of the table (Fig. 11).
2. Tilt the table to the desired angle, using the
scale for reference.
3. Tighten the bevel cutting knobs.
4. Follow the instructions for making a at cut
(Fig. 12).
WARNING
To avoid possible injury,
the rip fence should only
be used on the right side of the table while
making a bevel cut.
After Use
Verify the ON/OFF switch is in the OFF
position.
Unplug the tile saw from the power source.
Clean the tile saw after each use.
Emtpy and clean water trough.
Wipe off all exterior surfaces and tile blade.
Fig. 10
Angle Guide
Knob
Angle Guide
Fig. 11
Bevel Knob
Fig. 12