Skipala DIGR-1202/E User Manual

17/22
8.13. A25 Timer T11
Universal timer where the use is determined by
setting parameter A24 (Output OUT1).
8.14. A26 Timer T12
Universal timer where the use is determined by
setting parameter A24 (output OUT1).
8.15. A27 Timer T13
Universal timer where the use is determined by
setting parameter A24 (Output OUT1).
8.16. A28 Output OUT2
Determining the use of digital output OUT2. The setup
is similar to the parameter A24 (output OUT1). The
difference is in the numbers (marks) of the timers,
that are utilized by the output. Instead of timers T11,
T12, T13 (parameters A25, A26, A27) uses output OUT2
timers T21, T22, T23 (parameters A29, A30, A31).
8.17. A29 Timer T21
Universal timer where the use is determined by
setting parameter A28 (Output OUT2).
8.18. A30 Timer T22
Universal timer where the use is determined by
setting parameter A28 (Output OUT2).
8.19. A31 Timer T23
Universal timer where the use is determined by
setting parameter A28 (Output OUT2).
8.20. A32, A33
Reserved for future use.
8.21. A34 Frequency
The oscillations frequency is changed by omitting
a certain number of half-waves of the controlled
voltage sine curve. Therefore the change is not fluent,
but in steps. The value of the frequency parameter can
be set to 100 Hz, 50 Hz, 33 Hz.
8.22. A35
Unused parameter for this type of controller.

Skipala DIGR-1202/E Specifications

General

Brand	Skipala
Model	DIGR-1202/E
Category	Controller
Language	English