24
Alert ID setup
Each alert event can be associated with an ID
number. Such ID is used in the NMEA alarm
messages, ref sections 8.5.15 and 8.5.16 for details.
To set an alert ID, touch the value box next to the
alert type text. This opens a numeric touch
keyboard. Enter the ID number and touch the
“Return” key.
Touch “Esc” to leave the value unchanged.
To reset the ID value – enter the empty string. In
this case such alert type will not be presented in
the output stream (ALR message)
Alert Relays setup
When an alert event is changing the state, it is
possible to change the state of a relay in the
Interface Unit, which can be used to trigger
audible alarms or signal alert to other systems.
Touch the “Relay Num” button next to the
relevant alert type, and select the number of the
relay to trigger, or “Not Used” to disable relay
operation for that alert type. Ref 6.5.25 for relay
connections details.
Scrolling freeze
A scrolling history of alerts is shown in the bottom half of the display. Freeze the
monitoring window and use swipe technic – to study the alert history.
Touch the
button to stop new messages being
shown in the window. The button changes the shape
and the scroll bar appears.
The easiest way to scroll through the alarm history is to
use the swipe technique inside the monitoring window
To Next Page
Loading...