Skipper EMES60 - Speed Log Alerts Screen (Screen 3)

23
4.4 Speed log alerts screen (screen 3)
Note that this screen is only available with Administration privileges, ref 3.6
Screen layout
When a value that is measured by the system goes out of limits or failure mode occurs, an
alert is issued. This screen allows setting the individual alert ID’s for different alert events,
and assigns the relay (totally 2 relays) to the particular alert event.
Alert list
Generic alert list – ref 3.8.2
List of the alerts specific for the speed log
Low speed limit
Present speed value is less than the low speed limit
High speed limit
Present speed value is greater than the high speed limit
Lost speed alarm
Speed log cannot measure speed
Alert ID and Relay controls
Freeze alarm display
Current speed values
Disable audio alarm
Alert history (alert monitoring window)
List of all available alert types;
Indicated in red if alert condition exists
GNSS and THD data, ref 3.3
Alert settings: touch Alert button to set alert limits;