SKY-WATCHER WAVE150i Mount - Page 8

PART I: Installation of the WAVE150i Mount
)LJ10
8
)LJ12
1.5.2 Balance in Declination/Altitude axis
* Use the SynScan Pro app to slew the two axes and level the telescope with the telescope locking knobs on the upper
side. (Fig.10)
* Hold the telescope with left hand and remove the two declination locking knobs.(Fig.11)
* For tube ring mounting, slide the telescope in the ring to obtain balance.
* For non-tube ring mounting, keep holding the telescope, slightly loosen the two telescope locking knobs and slide
the dovetail bar in the saddle to obtain balance and then firmly tighten the two telescope locking knobs.(Fig.12)
* Lock the axis with the two declination locking knobs again.
)LJ11