Sky SKYLAM 1120 User Manual

Curled lamination
a. Upward curl
a. Loosen the top roll film tension.
b. Downward curl
b. Loosend the bottom roll film tension.
d. Blown main power fuse.
d. Replace the fuse.
a. Emergency switch is engaged.
Unclear lamination
a. The main roller temperatures
are too low and lamination
speed is too fast.
a. Raise the roller temperatures and lower the
lamination speed.
d. Replace the motor fuse.
The unit is not heating
up
a. The machine is in "COLD"
mode.
a. Switch to "HOT" mode.
b. Set temperature is lower than
the room temperature.
b. Raise the temperature according to the
recommended film temperature.
There is power, but
the rollers are not
running after the hot
button is pressed:
a. Disengage the emergency switch.
b. Safety cover is not closed.
b. Close the safety cover to active the safety
switch.
c. Guide table is not installed
correctly.
c. Properly install the paper guide so that the
micro switch is activated.
d. Blown motor fuse.
Symptom
Cause
Possible solution
Machine will not turn
on
a. Power plug is not plugged in.
a. Plug the power cord into appropriate outlet
b. Power switch is "off" positon.
b. Put the power switch to the "on" position.
c. Tripped circuit breaker.
c. Reset the circuit breaker.
11. TROUBLE SHOOTING
11

Sky SKYLAM 1120 Specifications

General

Brand	Sky
Model	SKYLAM 1120
Category	Laminator
Language	English