Skyjack SJ 4620 - Page 35

SJIII Compacts & Conventionals
December 2007 Page 37
TM
Section 2 - Operation Function Tests
Test Pothole Sensor •
WARNING
Ensure that you maintain three points of
contact to mount/dismount platform.
1. Use the ladder to dismount from platform
and place a block, approximately 3.75 cm,
under the hydraulic/electric tray.
2. Use the ladder of aerial platform to access
platform.
3. Close the gate.
4. Raise the platform until approximately a
height of 2 meters is reached and attempt
to drive forward or reverse.
Result: Aerial platform should not move
forward or backward.
5. Repeat the steps above with block placed
under battery tray.
Result: Aerial platform should not move
forward or backward.
Test Elevated Drive Speed•
WARNING
Be aware of overhead obstructions
or other possible hazards around the
aerial platform when lifting.
1. Ensure path of intended motion is clear.
2. Raise the platform until approximately a
height of 2 meters is reached and attempt
to drive forward or reverse.
Result: Aerial platform should move slower
than when it was in stowed position.
Pothole Protection
Device
Compact