Skyjack SJ40T User Manual

It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
FAMILIARIZATION
• Test Driving Speed
1. Depress and hold footswitch.
2. Raise “ ” main boom approximately
14 ft. (4 m) and then slowly move drive/
steer controller to full drive position.
Result: The maximum achievable drive
speed should be signicantly less than
stowed drive speed.
3. Lower boom to stowed position.
4. Extend “ ” y boom approximately
12 in. (30 cm) and then slowly move drive/
steer controller to full drive position.
Result: The maximum achievable drive
speed should be signicantly less than
stowed drive speed.
• Test Emergency Power
CAUTION
When operating on auxiliary power, do
not operate more than one function
at a time to avoid overloading 12-Volt
auxiliary pump motor. Do not use
emergency power unit continuously for
two minutes.
NOTE
To conserve battery power, test each
function through a partial cycle.
1. On platform control console, push in “ ”
emergency stop button to turn engine off.
2. Pull out “ ” emergency stop button.
3. Select “ ” on position from engine start/
on/off switch.
4. Depress and hold footswitch.
5. Turn “ ” emergency power switch to
“ ” on position and activate each function
control handle or switch.
Result: All boom and steer functions
should operate. Drive functions should
not operate.
NOTE
The emergency power unit has two-minute
duty cycle.
• Test Horn
1. Push “ ” horn pushbutton.
Result: Horn should sound.
Drive/Steer
Controller
Horn
Emergency Power
Switch
Emergency Stop
Engine Start/On/
Off Switch
Platform Leveling
Override Switch
Page 36
SJ 40T & SJ 45T
SJ 61T & SJ 66T
Function Tests Section 2 - Familiarization

Skyjack SJ40T Specifications

General

Brand	Skyjack
Model	SJ40T
Category	Boom Lifts
Language	English