EasyManuals Logo

Skyjack SJ68RT Series Operating Manual

Skyjack SJ68RT Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
Page 46 December 2007
Rough Terrain Scissors
TM
Start Operation Section 3 - Operation
3.8-3 To Activate Platform Control Console
1. Turn main power disconnect switch to “ ”on
position.
2. On base control console, pull out “ ” emergency
stop button.
3. For dual fuel engines, select fuel supply by moving
fuel switch to either “
” gasoline or “ ” liquid
propane gas position.
4. Insert key into platform/engine/base key switch
and turn it to platform “
” position to enable
platform controls.
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
5. Use the ladder of MEWP to access platform.
6. Close the gate.
7. On platform control console, pull out “
emergency stop button.
8. Turn low/high throttle switch to “ ” low throttle
position.
9. For cold dual fuel engines, select and hold “
choke switch. For cold diesel engines, select and
hold “
” glow plug switch for 15 to 20 seconds.
CAUTION
Do not start the engine in the high throttle
position.
10. Select and hold “ ” engine start switch until
engine starts, then release. Do not overcrank
starter. Release “
” choke switch after engine
starts (dual fuel).
3.8-4 To Raise or Lower Platform Using
Platform Control Console
WARNING
Be aware of overhead obstructions or
other possible hazards around the MEWP
when lifting.
WARNING
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate platform control console (refer to
Section 3.8-3).
2. On platform control console, select lift/drive switch
to “
” lift position.
3. Activate and hold “ ” enable trigger switch.
4. Move controller handle forward “ ” to raise or
backward “ ” to lower the platform, until desired
height is reached.
NOTE
Lowering is not proportional.
5. Return controller to neutral center position to stop.
Release enable trigger switch.
WARNING
To protect against unintended movement
of the MEWP, push in the emergency stop
button after you have arrived at your
desired location or elevation.
NOTE
If the tilt alarm sounds and the platform does
not, or only partially raises, immediately
lower the platform completely and ensure
that the MEWP is on a firm, level surface.

Other manuals for Skyjack SJ68RT Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Skyjack SJ68RT Series and is the answer not in the manual?

Skyjack SJ68RT Series Specifications

General IconGeneral
BrandSkyjack
ModelSJ68RT Series
CategoryScissor Lifts
LanguageEnglish

Related product manuals