INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT ATTEMPT
TO INSTALL OR OPERATE
Model: 3301P2
INTRODUCTION
This SKYTECH remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas
heating appliances. The system can be operated thermostatically, manually or with the built-in factory program inside the transmitter.
The built-in program has two segments, a weekday and a weekend segment. The factory presets are time periods for each day. SEE
PROGRAM SEQUENCE BELOW. Custom programming may be achieved after the initial setup has been performed.
This system operates on radio frequencies (RF) within a 20-foot range using non-directional signals. The system operates one of
1,048,576 security codes that are programmed into the transmitter at the factory; the remote receiver’s code must be matched to that of
the transmitter prior to initial use.
Built-in Factory Programs
Weekdays - Mon. Tues. Wed.Thurs. Fri.
Program 1 (P1)
5:00AM
9:00AM
Program 2 (P2)
4:00PM
10:00PM
72°
MORN
DAY
72°
Weekends - Sat. Sun.
Program 1 (P1)
5:00AM
9:00AM
Program 2 (P2)
4:00PM
10:00PM
72°
MORN
DAY
72°
Review COMMUNICATION SAFETY under TRANSMITTER section and THERMO SAFETY under REMOTE
RECEIVER section. These signal/temperature safety features shut down the replace system when a potentially
unsafe condition exists.
The transmitter operates on (2) AAA 1.5V batteries that
are included. Install the batteries supplied with the unit into
the battery compartment. It is recommended that
ALKALINE batteries always be used for this product. Be
sure the batteries are installed with the (+) and (-) ends
facing the correct direction.
DOWN
UP
MODE
COVER
CLOSED
DOWN
UP
MODE
SET
PROG
COVER OPEN
+
+
-
-
BACK OF
TRANSMITTER
Fig. 1 Transmitter Front and Back views.
INITIAL SET-UP OF TRANSMITTER
To begin the initial set-up proceed with the following
steps:
1. Remove the battery cover on the back of the transmitter.
Insert (2) ALKALINE AAA size 1.5 DCV batteries into the battery
compartment, positioning the (+) and (-) ends of the batteries as
indicated on the casing. When the batteries are inserted prop-
erly, the backlit LCD screen will light.
REV. 5-7-12 Page 1
Skytech: 3301P2
To Next Page
Need help?
General
