TROUBLE SHOOTING
If you encounter problems with your replace system, the problem may be with either the replace itself or with the
remote. Review the replace manufacturer’s operation manual to make sure all connections are properly made. Then
check the operation of the remote in the following manner:
• Make sure all batteries are correctly installed in the transmitter and receiver. Also check that the batteries are fully
charged.
• Check batteries in transmitter to make sure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for
tighter t.
• Be sure receiver and transmitter is within 20 to 25-foot operating range.
• Keep receiver from temperatures exceeding 130 °F. Battery life will be shortened if exposed to high
temperatures.
• If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.
• Make sure the hand-held transmitter and remote receiver are communicating properly (see LEARNING
TRANSMITTER TO RECEIVER section).
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT
For Technical Service, call:
U.S. INQUIRIES CANADIAN INQUIRIES
(888) 672-8929 or (260) 459-1703 (888) 472-3923
Web site: www.skytechsystem.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
SPECIFICATIONS
BATTERIES: Transmitter 3.0V- 2 ea. AAA 1.5V, Alkaline
Remote Receiver 6V – 4ea. AA 1.5 Alkaline FCC ID No.’s: transmitter –K9L3301TX; receiver – K9L301RX
Operating Frequency: 303.8MHZ
Canadian IC ID No.’s: transmitter – 2439-3301TX; receiver – 2439A-3301RX
REV. 5-7-12 Page 11
Skytech: 3301P2
To Next Page
Loading...
Need help?
General
