REV. 5-20-22 Page 9
Skytech: 5301P
If the receiver at anytime should reach 130º F, the receiver will automatically shut down and begin to beep 4 beeps every
2 seconds. Once the temperature has dropped between 120º F and 130º F, the user can reactivate the appliance by
pressing the MODE key, but the beeping will continue until temperatures drop below 120º F. This is to tell the user that the
receiver needs to be relocated to reduce temperatures.
If this situation happens, the receiver should be placed somewhere else where it will not reach temperatures in excess of
130º F.
THERMO SAFETY FEATURE
WALL MOUNT
The transmitter can be placed on a wall using the mount provided.
• Wood - Drill 1/8’’ pilot holes and install with screws provided.
• Plaster/Wallboard - Drill 1/4’’ holes, use a hammer to tap in the two plastic
anchors. Then install with the screws provided.
Fig. 26 Wall plate mounting.
BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter and receiver should be at least 12 months. Check and replace
all batteries:
• Annually.
• When operating range becomes reduced.
• When transmissions are not received by the remote receiver.
• If the remote receiver batteries measure less than 5.3 volts (all (4) batteries in combination).
• If the hand held transmitter batteries measure less than 5.3 volts all (4) batteries in combination).
TROUBLE SHOOTING
If you encounter problems with your replace system, the problem may be with either the replace itself or with the
remote. Review the replace manufacturer’s operation manual to make sure all connections are properly made. Then
check the operation of the remote in the following manner:
• Make sure all batteries are correctly installed in the transmitter and receiver. Also check that the batteries are fully
charged.
• Check batteries in transmitter to ensure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for
tighter t.
• Be sure receiver and transmitter is within 20 to 25-foot operating range.
• Keep receiver from temperatures exceeding 130º F. Battery life will be shortened if exposed to high temperatures.
• If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.
• Make sure the hand-held transmitter and remote receiver are communicating properly (see LEARNING
TRANSMITTER TO RECEIVER section).
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODI-
FICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT
To Next Page
Loading...
Need help?
General
