TRANSMITTER WALL CLIP
The transmitter can be hung on a wall using the clip provided. If the clip is
installed on a solid wood wall, drill 1/8" pilot holes and install with the screws
provided. If it is installed on a plaster/wallboard wall, first drill two 1/4" holes into
the wall. Then use a hammer to tap in the two plastic wall anchors flush with the
wall; then install the screws provided.
BATTERY LIFE
Life expectancy of the alkaline batteries in the remote can be up to 12 months depending on use of the servo function. Replace all
batteries annually. When the transmitter no longer operates the remote receiver from a distance it did previously (i.e., the transmitter's
range has decreased) or the remote receiver does not function at all, the batteries should be checked. It is important that the remote
receiver batteries are fully charged, providing combined output voltage of at least 4.5volts. The transmitter should operate with as little
as 2.5 volts battery power. NOTE: Extensive use of the SERVO MOTOR setting will reduce the receiver's battery life significantly.
TROUBLE SHOOTING
If you encounter problems with your fireplace system, the problem may be with the fireplace itself or it could be with the remote system.
Review the fireplace manufacturer's operation manual to make sure all connections are properly made. Then check the operation of
the remote in the following manner:
1. Make sure the batteries are correctly installed in the RECEIVER. One reversed battery will keep receiver from operating properly.
2. Check battery in TRANSMITTER to ensure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.
3. Be sure RECEIVER and TRANSMITTER is within 20 to 25-foot operating range.
4. Keep RECEIVER from temperatures exceeding 120° F. Battery life shortened when ambient temperatures are above 115° F.
5. If RECEIVER is installed in tightly enclosed metal surround, the operating distance will be shortened.
6. Clear Codes: Memory in the receiver might be full if the learn button is pressed too many times. If this happens it will not allow
any more codes to be learned and no audible beep will be heard. To clear memory, place the receiver slide switch into the
REMOTE position. Press the learn button and release after 10 seconds. You should hear three (3) long audible beeps indicating
all codes have cleared. You can now “learn” the transmitter to the receiver as described in the General Information Section.
SPECIFICATIONS
BATTERIES: Transmitter 12V - (A23)
Remote Receiver 6V - 4 ea. AA 1.5 Alkaline FCC ID No.'s: transmitter - K9L1001; receiver - K9L330IRX
Operating Frequency: 303.8 MHZ Canadian ISC ID No.'s: transmitter - 2439 102 728; receiver – 2439A-3301RX
FOR TECHNICAL U.S. INQUIRIES CANADIAN INQUIRIES
SERVICE, CALL: (855) 498-8324 or (260) 459-1703 (877) 472-3923
For Sales: (888) 672-8929
Website: skytechpg.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
To Next Page
Loading...
Need help?
General
