REV. 1/26/06 Page 7 of 9
FREQUENCY (DISTANCE) ADJUSTMENT PROCEDURE
RECEIVER ADJUSTMENT
1. To adjust at the receiver, use a small slotted screwdriver. Turn the adjustment (ADJ)
screw counter-clockwise about 5° or maximum of 1/8 turn. This should correct the
distance problem.
2. If that does not correct the problem, return adjustment screw to original position and then
turn adjustment screw clockwise.
This adjustment is like tuning your radio. If you keep turning the adjustment screw, in either
direction, you will go past the proper setting (tuning).
SPECIFICATIONS
BATTERIES: Transmitter (2) 1.5 volt AAA t bateries
Remote Receiver 6V - 4 ea. AA 1.5 Alkaline FCC ID No.'s: transmitter - K9L1003TX; receiver - K9L300IRX
Operating Frequency: 303.8 MHZ Canadian IC ID No.'s: transmitter – 2439-1003TX; receiver - 2439 102 728A
FOR TECHNICAL SERVICE, CALL
: U. S. INQUIRIES CANADIAN INQUIRIES
888/672-8929 or 877/472-3923
260/459-1703
WEBSITE: skytechsystem.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC.
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
To Next Page
Loading...
Need help?
General
