DVI-300 Installation Manual
Document Rev. 01.004 DOC0456 Page 8 of 31
Restricted Proprietary and Confidential Information
Section 5 — Configuration of the DVI-300
This section contains instructions on how to configure and set up the DVI-300 system.
Section 6 — Post Installation Tests
This section contains instructions for tests to be performed after installation, in order to confirm that the system
has been installed correctly.
Section 7 — Airworthiness Limitations
This section describes the installation and operational limitations of the DVI-300 system.
Section 8 — Maintenance and Continued Airworthiness
This section describes the steps required for the continued airworthiness of the DVI-300 system.
Section 9 — Firmware Updates
This section indicates the methods available to update the DVI-300 and where to find the required instructions.
Section 10 — DVI-300 Human Machine Interface
This section provides a brief description of the DVI-300 human machine interface components.
Section 11 — Appendices
1.2.1 AUDIENCE
This manual is intended for qualified aircraft avionics technicians, referred to as installers. It assumes that the
installer is familiar with the tools, materials, and techniques of wiring and metal work required for installing radios,
antennas, and related components into aircraft.
1.2.2 REFERENCES
Additional information about the components of the ISAT-200 system can be found in the ISAT-200 Installation
Manual, the DVI-300 User's Guide, and the CDU-300 User’s Guide.
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...
Need help?
General
