SkyWave IDP-690 - Figure 35 Wires and Solder Cups; Figure 36 O-Ring over Connector Body; Figure 37 Silicone in the Connector

IDP 600 Terminal Series - Hardware Guide
© SkyWave Proprietary 37 T200, Version 02
Figure 35 Wires and Solder Cups
6. Ensure the O-ring is in place over the connector body as shown in Figure 36.
Figure 36 O-Ring over Connector Body
7. Slide the coupling ring over the connector body and give it a twist to prevent it from
falling off.
8. Use silicone sealant to completely fill the end of the connector and the area between
the wires (Figure 37).
Figure 37 Silicone in the Connector
9. Slide the back shell up the cable as close as possible to the connector body and fill it
with silicone sealant (Figure 38).