SMA SI8.0H-11 - Sunny Remote Control

3 Product Description SMA Solar Technology AG
16 SI30M-44M-60H-80H-BE-en-32 Operating Manual
3.4 Sunny Remote Control
You can configure and control the system from a central location using the Sunny Remote Control display.
Figure3: Layout of the Sunny Remote Control
Service interface, SD memory card
The Sunny Remote Control has a slot for SD memory cards. The SD memory card stores data for system control and
facilitates service work. The SD memory card also allows you to update the firmware on the Sunny Island inverter. The
following data is stored on the SD memory card:
• Parameter settings
• Every minute, measurement data from the areas:
– Battery
– Sunny Island
– Generator
– Utility grid
– Stand-alone grid
• Events and errors
• Statistical values of the battery
The SD memory card must be formatted as FAT-16 or FAT-32.
Position Designation Explanation
A Display Four-line display shows operating data (e.g., operating state, display values) and
events, warnings, or errors on the Sunny Island inverter.
The display backlight is automatically deactivated after a short period of inactivity.
B Switch Pressing the button will turn on the backlight, confirm parameters, or switch the level
within a menu. The return symbol " " in the display indicates when you can perform
an action by pressing the button.
Turning the button will switch on the backlight, change parameters, or navigate within a
menu level.
C SD memory card
slot
‒