SMA SI8.0H-11 - Stopping the System; Switching off the Sunny Island; Tripping the Emergency Disconnection of the System

SMA Solar Technology AG 4 Starting and Stopping the System
Operating Manual SI30M-44M-60H-80H-BE-en-32 19
4.3 Stopping the System
If you stop the system, the Sunny Island switches from operation into standby mode. In standby mode, the Sunny Island
discharges the battery due to its standby consumption. Tip: For longer shut-down periods, switch off the Sunny Island
(see Section4.4, page19).
Procedure:
• Press and hold the start-stop button on the Sunny Island until the
inverter LED is glowing orange.
or
Press and hold the button on the Sunny Remote Control until the progress bar has run down.
☑ The inverter LED on each Sunny Island is glowing orange. The Sunny Island inverters are in standby mode.
4.4 Switching off the Sunny Island
Requirement:
☐ The system is stopped.
Procedure:
• Press and hold the "Off" button on the Sunny Island until an
acoustic signal sounds.
☑ The inverter LED is off on all Sunny Island inverters.
4.5 Tripping the Emergency Disconnection of the System
Effects of an emergency disconnection
Emergency disconnection triggers the uncontrolled shutdown of the system and unsaved data is lost.
• Use emergency disconnection only to avoid danger or consequential damage.